For motorcycle owners who care about the best care for their mounts, this one tip is a must know.
It turns out that there is an easy way to drain the brake fluid for you to apply.
This way of draining the brake fluid, you don't have to shake the brake lever during the process. bleeding or brake fluid refilling.
As quoted from Gridoto.comAfter trying to apply it, it turns out that this method is very practical and speeds up the brake fluid drain process.
As you know, one of the most annoying things about draining brake fluid is the process of refilling it.
Normally, the filling method is done by putting brake fluid into the tube in the brake master, then pumping or shaking the brake lever until the brake fluid fills all parts in the brake system.
However, this method is troublesome and requires a lot of time and energy.
"If you want to be quick, you can use an injection tool to insert the brake fluid," said Lukman.
So, you can prepare a large injection that is widely sold at children's toy stores.
Also, buy a small clear aquarium hose that is commonly used for aerator hose.
The application stage, first make sure all braking parts have been cleaned as well as installed and ready to put new brake fluid.
After that, enter the brake fluid into the syringe that was also attached to the slang earlier.
For the filling process, we have to loosen the brake line bolt on the caliper using key 8.
Then insert the end of the tube connected to the injection into the nipple head.
If it is installed, you just need to inject brake fluid until it fills up the brake fluid tube in the brake master.
Once full, tighten the nipple bolt using key 8, close the brake fluid tube in the brake master, and the brakes are ready to use.
EN 
ID